Hold the frame by the grip in the right hand and grasp the muzzle of the barrel and turn to the left 90 degrees and lift the barrel off the frame.ĥ. The striker, spring and follower pin can now be removed from the breech block portion of the slide.Ĥ. Hold the button depressed, pull the slide back a short distance and lift straight up, then ease the slide forward to remove the slide and recoil spring from the barrel. This button controls the grip safety and also the latch under the slide that engages a groove to keep the slide in place.ģ. Press the button at the top rear of the left grip (the rear most of the two buttons on 9 mm Kurz versions). First, remove the magazine and operate the slide at least two times to ensure that that there is no cartridge in the chamber.Ģ. Therefore, I will explain the procedure with help from this book - ”German Pistols and Revolvers 1871-1945″ by Ian V. The Ortgies is one of the renowned “Puzzle” guns which offers no hint about how start the disassembly procedure. The natural action of gripping the pistol automatically disengages the safety and the disassembly button must again be pressed to re-engage the safety. When the grip safety protrudes from the rear of the grip, the pistol is in the safe mode. The only safety on the 6.35 mm and 7.65 mm versions is the grip safety which is engaged (made safe) by pressing the disassembly button on the frame at the top rear of the left grip panel. The design is a fairly straight forward blowback pistol. These are “exceptionally neat and tidy” in appearance and were widely exported, particularly to the U. The pistols are virtually identical except for size.
![380 pistol clip for the ortgies pistol 380 pistol clip for the ortgies pistol](https://i.pinimg.com/736x/69/2b/6c/692b6cc121d86f54d16c3181cea143da.jpg)
Ortgies pistols were made in 6.35 mm (.25ACP), 7.65 mm (.32 ACP) and 9 mm Kurz (.380 ACP). Pistols made by Ortgies had a monogrammed “H” and “O” on a metal stud inlaid in the grip panels.ĭeutsche Werke changed the monogram on the grip panels to an ornamental “D” formed by a mythical animal with a long tail curling over its head.
![380 pistol clip for the ortgies pistol 380 pistol clip for the ortgies pistol](https://cdn.rockislandauction.com/dev_cdn/1030/330.jpg)
Deutsche Werke continued to make the Ortgies pistol through the 1920’s and 1930’s. Some 10,000 pistols were made by Ortgies before Deutsche Werke of Erfurt purchased the patents, stock, and tools, circa 1924. These pistols were constructed based on Ortgies’ patents issued on various dates in 19, which covered the barrel mounting, the method of attaching the grips, and the disconnector (which allowed only one shot to be fired per each pull of the trigger) Ortgies pistols were made by Herman Ortgies of Erfurt, Germany in the early 1920’s.